subject: Beaded Necklaces - Buying [print this page] Making a beaded necklaces requires time, patience and also the right tools, but is something nearly everyone can learn to perform with ease. Follow these steps to learn extra about how to make your own beaded necklaces.
Tools and Supplies
Prior to you may start making your beaded necklaces, it can be important that you've the right tools and supplies on hand. This will ensure you bead a top quality necklace that will last a long time. You will need the following items: jewelry wire, beading needle, beading thread, beads, beading design board, a flat surface to work on, craft glue, scissors, along with a pair of flat nose pliers.
Step One: Cutting Your Jewelry Wire
Choose the length you want for the beaded necklaces, making sure to have an additional couple of inches to work with to make beading easier.
Step Two: Making Sure You Have Enough Beads and Laying Out the Design
Check to make sure you have plenty of beads and use the bead design board to layout the beads flat. Step 3: Knot the Jewelry Wire
Tie a knot at one in the ends with the thread. Take a pair of scissors to cut off any extra thread. Add a bead to the necklace and pull the thread through the open hole so the knot can rest against it. Apply a little craft glue and let it dry to ensure it does not come undone.
Step Four: Beading the Necklace
String the beads whilst threading around the opposite bead tip to ensure that the strung beads will not face the open end of the tip.
Step Five: Attaching the Tip and Clasp
Tie a loose knot in the thread end. Thrust the knot down into the bead tip which has a straight pin. Ensure the knot is resting against the hole Use scissors to trim any extra remaining thread. Use the pliers to close the bead tip.
These bead guidelines ought to be attached to both ends of your thread, as one will allow the clasp to attach and close the necklace, although the other will hold the clasp.Attach one of your clasp pieces onto a bead tip hook to ensure the loops are attached to each other. Use pliers to close the titanium rings, one over the other. Do this yet again for the other clasp for the opposite end of the necklaces for men.
by: Margit Brookshire
welcome to Insurances.net (https://www.insurances.net)
