subject: Creating Ethnic Skin Tones for Your Reborn Baby Doll [print this page] Creating Ethnic Skin Tones for Your Reborn Baby Doll
When creating ethnic skintones on reborn doll whether utilizing a kit or reborning a factory painted doll, the method is relatively the same. If employing a 'play' doll it is important to strip and sand your kit, filling hot water into the limbs to get rid of any wax layers, this will permit the dye to take hold.
Asian skintones is the same procedure as creating a Caucasian baby, just different colour mixes are vital. Primary preparation, depending on the colour of your kit may be required in the form of a dye. If your kit is too pink it is advised to do a ten minute purple dye to tone it down a little, ready for your asian paint mix. Soak the doll kit into a liquid dye for ten minutes. take it out and leave to dry for at least 24 hours before examining the colour, this grants the dye enough time to take hold in the vinyl and will give you a more accurate hint on the colour. Once happy with the colour of your kit, take a small amount of flesh 04 and a larger amount of flesh 06 and mix with your unscented solvent or thinning medium until you have a waterlike consistency. You can conduct experiment with this colour a bit until you are delighted that it is the right shade for an asian skintone.
The African American skin tone for reborn dolls is a easy procedure, with the initial preparation being imperative to the overall result. Starting with your water soluble dye add 4 parts tan, 2 part dark brown, with the fewest amount of yellow to 5 parts water. This is the standard mixture used for staining your kit before utilizing thin layering of heat set paints. Depending on the darkness of skin tone you are planning to make, your kit can be left in the solution for 10 to 30 minutes depending on the concentration of color you wish to achieve. For African American it is advised to detach after 15mins, the process can be repeated if your not content with the depth of color. After ejection from your dye mix clean carefully and dry, leave your pieces 24hours to cure before creating any decisions on darkening, this will give the dye time to really take hold in the vinyl and give you an exact idea on color.
For a light Hispanic skin, Using a water based or water soluble dye, mix 1 part dark brown to 4 parts water in a pitcher or similar to dip your doll body parts. Vinyl will float so it is vital to lay something on top of the water or gently wedge something into the pieces so they are fully submerged for the period of dyeing. Depending on what tone of skin you are hoping to get, dye time can be anywhere from 10 minutes to 30 minutes. Take out your parts from the mixture after ten minutes and clean thoroughly, leave to cure for at least 24 hours before formulating any decisions on colour, you will need this time for the colour to settle and can always do a second dip, as with most reborning, less is more, you can always darken later, lightening is a time consuming procedure of stripping or colour harmonising.
welcome to Insurances.net (https://www.insurances.net)
