Board logo

subject: The Modern Pool Cue - What You Must Know about the Parts of a Billiards Cue Before You Buy [print this page]


The Modern Pool Cue - What You Must Know about the Parts of a Billiards Cue Before You Buy

The Modern Pool Cue - What You Must Know about the Parts of a Billiards Cue Before You Buy

Think that a pool cue is just a simple piece of long wood? Think again. The modern billiards cue is nothing short of a technological wonder, combing the same craftsmanship that cue makers have been using for centuries with 21st century science. Before you spend your hard earned money on a billiards cue, it pays to know exactly what you are getting. Here are the parts of a billiards cue that you should know before you get started.

Tip Just like the name sounds like, the tip is the very end of the cue, the part that you actually use to hit the billiards balls. In almost every case, this is made of a toughened leather. But just how hard this material is can affect how it plays. If a tip is really hard a tough, then it hits stiffer and harder. If it is softer, then it is easier to get a little spin on the ball, which is sometimes necessary for tricky shots.

Ferrule - In order to keep your tip perfectly straight and stable, your pool cue also has a ferrule that connects the tip and the shaft. In addition to keeping the tip in place, it also protect yours shaft from being damaged as a result of hard hits.
The Modern Pool Cue - What You Must Know about the Parts of a Billiards Cue Before You Buy


Shaft The shaft is almost certainly the most important part of the entire cue. It is the tapered piece of wood that stretches from the tip down to the collar. It's important because the structure of this piece is what is probably most important for how powerful your cue is. In most cues, it is just a solid piece of hard rock maple. Sometimes, however, you actually get billiard cue shafts that are made up of four, six, or even eight split pieces that are formed together to make one cue, which leads to a more consistent hit.

Joint - The joint is the part of the shaft where you attach the butt of the cue. (This is only applicable to two piece cues.)

Pin - The pin of the billiards cue is a screw that goes into the joint. However, there are some pins that aren't screws at all, but rather just locking mechanisms that fit into the joint. This allows you to attach the shaft and the butt together easily, with one twist, rather than having to twist it around several times.

Inlays - Inlays are probably the most distinctive features of a pool cue, and the part that really stands out. What inlays are made of can be really varied, but the most popular materials are probably exotic woods, metals, and mother of pearl.

Wrap - The wrap of a pool cue is the part that you have to grasp when you go to take a shot. Most cue manufacturers prefer to use Irish linen on this part of the cue, however, you can see exceptions in cues that have leather, nylon, or no wrap at all.

Rubber Bumper - To protect the butt of a pool cue, most have a rubber bumper at the end. This allows you to stand up the pool cue in a stand without any risk of damaging one end.




welcome to Insurances.net (https://www.insurances.net) Powered by Discuz! 5.5.0   (php7, mysql8 recode on 2018)